Leading 10 usual forklift crashes ， forklift procedure need to take notice of these issues ！.

Don't undervalue the forklift at work. If the operation is not good, there will be major mishaps in minutes, and there are numerous mishaps including forklifts.

Situation 1: The forklift freight obstructed the vehicle driver's sight, and the person in front could not be discovered, leading to a moving crash.
Instance 2: In order to keep the balance of the forklift when raising hefty items, the staff members utilized their body weight as the counterweight, which virtually triggered casualties.
Case 3: The width of the forklift freight exceeds the permitted width of the route and holds on the roadside shelf, which nearly triggers an mishap.
Case 4: Forklift is speeding up and surrender during a turn.
Situation 5: The forklift motorist did not observe the pedestrian, and the pedestrian did not discover the forklift.
Instance 6: The forklift raises the employees illegally, the forklift chauffeur does not put on the seat belt, the forklift lifter falls and the chauffeur is squashed when the forklift surrender.
Situation 7: The forklift driver did not use a seat belt and fell from the car when it surrendered and was squashed.
Forklift procedure must focus on these matters ：.

Beginning.
1. Prior to starting, observe the surroundings, and after validating that there are no challenges that impede the safety of driving, honk the horn first and then start.
2. For lorries with hydraulic ( atmospheric pressure) brakes, the brake hydraulic pressure ( atmospheric pressure) gauge have to be safe before beginning.
3. When the forklift starts with a tons, the driver should first verify that the lots is steady and dependable.
4. The start must be sluggish and consistent.

Driving.
1. When driving, the height between the bottom end of the fork and the ground ought to be maintained 300mm-400mm, and the mast must be tilted in reverse. .
2. Do not lift the fork too high when driving. When going into and leaving the work website or while driving, be careful that there will certainly be no challenges overhead. When the load is traveling, the fork has to not be raised expensive, which will influence the stability of the forklift. .
3. After discharging, the fork must be lowered to the normal driving placement before driving. .
4. When transforming, if there are pedestrians or cars close by, the driving signal needs to be issued initially. High-speed sharp turns are restricted. High-speed doglegs will create the automobile to shed lateral stability and topple. .
5. When the forklift is downhill, it is strictly restricted to shut off the fire and slide, and it is forbidden to brake all of a sudden while driving with loads unless there are special scenarios.
6. When the forklift is running, it has to follow the website traffic rules in the factory and have to keep a certain safety range from the lorry in front. .
7. When the forklift is running, the tons has to remain in the lowest position that does not hinder the driving, and the gantry should be correctly tilted back. The load shall not be increased other than when stacking or loading. .
8. The height of the load need to not block the chauffeur's view. In special scenarios, when the thing influences the forward vision, drive at a reduced rate when reversing.
9. It is prohibited to switch on the ramp, nor to drive throughout the ramp. .
10. The secure driving rate of the forklift in the manufacturing facility location is 5 km/h, and it needs to drive safely at a reduced rate when entering the production Electric Forklift Truck for Warehouse workshop location. .
11. When the forklift is raised, lifted or driven, it is forbidden for personnel to stand on the fork to hold things and play a stabilizing duty. .
12. If problems are discovered, they will certainly be repaired and reported in a prompt fashion, and they will certainly never ever operate with ailments or hide them.

filling Stand-on Electric Pallet Stacker and dumping.
1. When fork-loading products, the distance in between the two forks should be adjusted as required to make the lots of both forks well balanced and not manipulated, and one side of the thing ought to protest the rack. .
2. It is restricted to deal with a solitary fork or utilize a fork top or pull. In unique scenarios, security indication should be established to remind bordering pedestrians. .
3. In the process of filling and dumping items, the forklift has to be braked with the brake. .
4. The speed of the lorry need to be sluggish and consistent. Beware not to roll the wheels on the dunnage, so as not to extend the rolled objects and injure individuals. .
5. When utilizing a fork to fork the goods, the fork should be as deep as feasible under the lots, and it ought to be kept in mind that the fork suggestion should not touch other goods or objects. The load must be stabilized with marginal back tilt of the gantry so that the load does not move in reverse. The pole can be tilted forward somewhat when the lots is lowered to allow for simple placement of the lots and extraction of the forks. .
6. It is forbidden to fork goods at broadband and collide with tough objects with the fork head. .
7. When the forklift is working, it is prohibited for individuals to stand around the fork, so regarding avoid the collapse of the goods and harm people. .
8. Overwhelming is banned, and it is prohibited to make use of forks to raise personnel to participate in high-altitude operations to stay clear of high-altitude dropping accidents. .
9. It is not enabled to utilize the brake inertia to slide, put, round or roll things. .
10. It is not permitted to make use of forks to choose, turn pallet discharge.

Leaving .
1. It is restricted to leave the forklift when the products on the fork are in the air. Before leaving the forklift, you must unload the goods or lower the fork structure.
2. Pull the hand brake take care of to dead or dispirit the parking brake switch.
3. The engine is turned off and the power is removed. (Except for unique conditions, such as the vehicle driver does not leave the automobile's line of vision and does not exceed 1 minute).
4. Remove the key. .

Forklift Operation Precautions.
1. Before and after the forklift procedure, the appearance ought to be checked, and fuel, lubricating oil and air conditioning water ought to be added.
2. Inspect the safety efficiency of beginning, running and stopping.
3. Inspect whether the lights and horn signals are complete and reliable.
4. Throughout the procedure of the forklift, examine whether the stress and temperature are regular.
5. After the forklift is running, the external leakage must likewise be inspected and the seals ought to be changed in time.

Forklift Safety Operation Specifications.
1. You should inspect before leaving the automobile;.
2. When you come across somebody before you during driving, you should send out a signal at a distance of 5 m;.
3. The driving speed in the factory does not go beyond 5 km/h;.
4. When driving, the nadir of the freight need to be 0.3 m ~ 0.4 m above the ground;.
5. The turning ought to not be also sharp to prevent the propensity of "free turning";.
6. Running up and down the incline ought to be slow-moving and consistent, and no switching on the incline is enabled.
7. Do not drive throughout the gradient. When the gradient is higher than 10%, the automobile must be driven in reverse when going downhill;.
8. When the forklift workers lug the goods and progress, if they come across large or hefty items and most likely to the driver's view, they must take the turning around exercise
.
The "Eight Prohibitions" should be complied with in the operation.
1. Solitary fork procedure is not allowed.
2. It is not enabled to raise the goods for long distance driving.
3. It is not permitted to grab the goods by handing over the pallet with the fork.
4. It is not permitted to directly shovel chemicals, flammables and various other hazardous chemicals with forks.
5. It is not permitted to utilize inertia force to grab the goods.
6. It is not permitted to make use of braking pressure to expatriation round or easy-to-roll items.
7. It is not enabled to bring individuals to work on the pallet or fork, and it is purely prohibited to stand under the fork after the fork is raised.
8. Do not drive laterally on inclines
.
Auto parking is not permitted under the list below conditions.
1. Contours, narrow roadways, train crossings;.
2. Sections with a longitudinal slope greater than 5%.
3. When there is an obstacle on one side of the road, the opposite side of the section with the exact same length as the challenge need to be within 20 meters at each end.

Web：https://www.onenforklifts.com/
Email：[email protected]
Phone：+86 13827083844